Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Linear Gate Repair in North Richland Hills: What to Know First
Linear gate repair in North Richland Hills usually means one of three things: an opener that stopped responding to the remote, a gate that drags or sags, or a safety edge that’s sending a false signal and keeping the gate from closing. Most Linear jobs we see are back on track in one visit, usually under $400, and the honest truth is that the cheapest fix is often a $45 part, not a new opener. This page is for homeowners with a Linear brand gate or opener who want someone to actually diagnose the problem before reaching for a replacement quote. If your Linear gate quit on you this morning, call (817) 241-4067 and describe what it is or isn’t doing. We’ll give you a straight answer about what we suspect and what it might cost, and we’ll show up when we say we will.
How Linear Products Fail - and How We Fix Them
- Linear LSO and LDO series openers: the capacitor gives out, not the motor. We replace more start capacitors in Linear slide and swing operators than anything else. The symptom is a gate that hums or buzzes for a second and then stops, or trips the breaker. The motor itself is almost always fine. A generic opener company will tell you the whole unit is shot. We carry the right capacitor for the LSO line on the truck, and we’ll show you the old one with a bulged top before we put in the new one.
- Linear APeX line: the limit switch drifts on its own. The APeX series runs on a magnetic limit system that picks up interference from nearby high-voltage lines, and in North Richland Hills we’re close enough to the Oncor corridors off Loop 820 that it happens more than you’d think. The gate will open fine, then stop a foot short of closed or overshoot the open position and slam the stop. We reset the limits, and if the interference keeps throwing them, we add an isolated control board mount that breaks the loop. It’s a known quirk, not a sign you need a different brand.
- Linear MegaCode receivers: antenna placement gets ignored, and remotes keep losing sync. The MegaCode receiver antenna is a thin wire most installers zip-tie to the metal post, which grounds out the signal. Your remote works from twenty feet away but not from the street, or only when you hold it above the dash. We relocate the antenna outside the post and re-sync the rolling code, and the range comes right back. This one is rarely the remote’s fault, and we tell you that before touching anything.
- Linear MDR and DDR gate operators: the gearbox oil turns to sludge in Texas heat. North Richland Hills summers sit around 100 degrees for weeks, and those sealed gearboxes cook. The gate runs slow after three or four years, or makes a grinding sound on startup. We drain the old oil and refill with a heavier grade meant for high-heat climates, and that gives the unit years more life than the average at 100,000 cycles will suggest.
- Linear safety edges on all models: the rubber cracks and fills with water. Every Linear gate in North Richland Hills lives with our freeze-thaw and clay soil, and the safety edge strip along the leading edge is the first casualty. Water gets into the crack, shorts the contact, and the gate refuses to close or reverses constantly. We replace the edge strip with a heavier aftermarket version that is actually more watertight than the factory part, then we test the reversal pressure under load so the safety system works as Linear intended.
Our Linear Gate Repair Process
- 1
You call, describe the symptom, and we show up on time. The phone is answered by a live person, not a menu, at (817) 241-4067. We schedule a window and stick to it.
- 2
We diagnose in the driveway, not from a photo. A Linear gate failure is usually one of the things we listed above, but we test voltage at the board, amp draw at the motor, and the mechanical alignment before we name the part. You watch us work if you want.
- 3
We give you a written price before touching anything. The number we quote is the number on the invoice. If it is a worn hinge and not the opener, we say so, even though the opener replacement would cost more and be easier to sell.
- 4
We repair with OEM Linear parts when the unit is under warranty or when the factory part is the one that matters. For wear items like safety edges, capacitors, and gear oil, we use aftermarket parts that outlast the factory spec in North Richland Hills heat. We tell you which we are using and why, and the part is on the truck in most cases.
- 5
We test the full cycle, adjust force and limits under load, and clean up. We run the gate through open and close a dozen times, trip the safety edge, and confirm the remotes and keypad sync. We leave the area cleaner than we found it.
- 6
The 90-Day Done Right Promise applies, in writing, every time. If it isn’t done right, one call brings us back. We do not hedge on that. It is stamped on your invoice.
What Linear Gate Repair Costs in North Richland Hills
Most Linear gate repairs in North Richland Hills land between $185 and $650, with opener replacement at the top end when the board and motor are both gone.
- Capacitor, fuse, or antenna relocation: $85-$185
- Safety edge replacement, tested under load: $220-$380
- Limit switch reset or interference isolation on APeX: $150-$275
- Gearbox oil service on MDR/DDR: $125-$225
- Full Linear opener replacement, installed and tested: $1,150-$2,450 depending on operator size and post work
The price moves based on post condition, soil settling, and whether previous repairs left wiring we need to clean up. The estimate is free, the price is agreed before we touch a tool, and you pay exactly what is written. Call (817) 241-4067 for a straight quote over the phone or in person.
Why North Richland Hills Homeowners Call Gatewood Fence & Gate for Linear Work
We have been fixing gates in North Richland Hills since 2001, and Hal Gatewood is the one who answers questions and works the jobs. His name is on the shop, and the shop is down the road. That is the oldest accountability there is. We know Linear openers and the way they behave in this specific climate, and when a part is backordered or a unit is truly beyond saving, we service the other major brands in this market: LiftMaster, Mighty Mule, Ghost Controls, DoorKing, and the other operators on North Richland Hills driveways. We carry the parts for them too. If I hand you my number, use it. That is what it is there for.
FAQs
If your Linear opener is still under the manufacturer’s warranty, the parts are covered but the service call is generally not. We follow warranty-safe practices on every Linear job and use OEM parts when the unit is under warranty, so you do not void coverage with an aftermarket part. Bring us your receipt date and we will tell you where you stand before work starts.
Most parts are still available, but some older Linear control boards have been discontinued by the manufacturer. We repair boards on the bench before we recommend replacing them, and we keep quality aftermarket parts for the consumables that fail most in North Richland Hills heat. If a board is truly dead, we will show you why.
We repair first, always. Most Linear openers that get condemned by other companies need a capacitor, a limit reset, or a safety edge. If the motor itself is burned out or the board is fried, we will quote a full replacement and you decide with the actual numbers in front of you.
If the gate is stuck open and the security of the property depends on it, call (817) 241-4067. We talk to you right away and aim for same-day for dangerous or unsecured situations. A gate that is just noisy or slow can wait a day or two, and we will tell you that honestly.
That behavior is almost always a safety edge or a photo eye sending a false obstruction signal or a limit switch that lost its position. We test both before replacing anything, and often the fix is a reset, not a part.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving North Richland Hills and nearby areas.





Before
After
Before
After
Before
After