Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterDoorKing Access Control Installation: The North Richland Hills Owner’s Guide
DoorKing access control installation in North Richland Hills typically runs $385 to $1,200 depending on what failed and what you’re upgrading to, and we stock the common DoorKing parts on the truck so most jobs get done the same day. Most people find out the honest way: a keypad goes dark after a storm, a card reader quits talking to the board, or the whole system works fine until the sun hits it and then the gate won’t open. You’ve got a DoorKing that’s half-working, and what you want is someone who knows the difference between a bad board and a bad wire before they start swapping both.
Which DoorKing Models This Applies To
The line that gives North Richland Hills homeowners the most service calls is the DoorKing 1800 and 1802 series: the telephone entry units you see on just about every driveway gate off Rufe Snow and Davis Boulevard. The 1812 Classic, the 1830 series with the larger display, and the 9000-series vehicle detectors all take different circuit boards, and here’s the gotcha: a DoorKing 1812 board will physically plug into an 1830 cabinet, but the firmware won’t run right and the keypad will behave like it’s haunted. We match by the model number on the silver sticker inside the cabinet door, not by what the previous installer said it was. For high-use systems around Smithfield Road businesses and the HOAs off Mid Cities Boulevard, we’ll recommend genuine DoorKing boards over the offshore aftermarket versions; the savings look good until the relay contacts oxidize in our humidity and you’re paying twice.
Signs Your DoorKing Access Control Installation Is Failing
- Keypad lights up but won’t release the gate. The relay on the main board is sticking. Common on DoorKing units older than eight years, especially after a Texas thunderstorm season.
- Gate opens fine from the remote but not from the keypad. The access control board has lost its programming or the keypad ribbon cable has a cracked trace. We see this a lot when the cabinet faces west and cooks in the July sun.
- Tenants or family codes stop working one at a time. The memory chip is failing. DoorKing boards save codes to an EEPROM, and heat is what kills them eventually.
- Telephone entry unit won’t dial out or calls but has no audio. Usually a surge-damaged phone module after a lightning strike nearby. North Richland Hills gets its share of summer storms.
- System works in the morning, dead by afternoon. Heat-related component failure on the power supply. We call it the “3 o’clock gate” because that’s when owners finally notice they can’t get in.
Replacement Cost & What’s Included
A new DoorKing access control board installed in North Richland Hills usually lands between $450 and $850 parts and labor, with full keypad or telephone entry units running $800 to $1,200 installed. The honest driver is which board your model needs and whether the previous installer left you clean wiring or a nest of wire nuts. We quote the price in writing before the first tool comes off the truck, and that price is the price unless we open the cabinet and find something nobody could have known was in there. If that happens we stop, call you, show you, and get a yes before we go further. The labor is covered by our 90-Day Done Right Promise, and the OEM DoorKing parts carry their own manufacturer warranty.
DIY or Call Us?
Here’s the honest version. The access control side of a DoorKing system runs on low voltage, so it’s not the kind of electrical danger that kills a careless homeowner. What hurts you on a gate is the operator, the gears, and the chain; the access control is what tells those parts to move. The danger with a DIY DoorKing board swap is what you don’t recognize: an antenna wire reversed, a ground loop that makes the keypad buzz, or a vehicle detector wired into the wrong terminal and now the gate won’t close when the neighbor’s Silverado is in the loop. If you’re comfortable testing with a multimeter, you can check your power supply and fuses. If the board itself is suspect, that’s a call to us, not a Saturday project. Hal Gatewood has been fixing these exact units in North Richland Hills since 2001, and most of the repairs we do now are un-doing what a previous DIY attempt or a fly-by-night installer left behind. And if I hand you my number, use it, that’s what it’s there for.
FAQs
In North Richland Hills, plan on 7 to 12 years for the board itself. Our heat and humidity age capacitors and solder joints faster than the manufacturer’s national average would suggest, and units mounted in direct afternoon sun fail soonest.
Sometimes. A blown capacitor or a failed relay often can be replaced at the component level for $80 to $180, and we’ll do that before we sell you a whole board if the board’s overall condition warrants the repair. If the board shows heat damage across multiple components, replacement is the honest call. Give us a ring at (817) 241-4067 and we’ll tell you which one you’re looking at.
Most single-board swaps and keypad replacements are done in two to three hours on site, same day. Full telephone entry units with new wiring can take four to six hours, and if we don’t have the exact board your model needs, we’ll order it and get you back on the schedule as soon as it lands.
We stock the common DoorKing replacement boards, keypads, power supplies, and card readers on the truck, along with parts for LiftMaster, Mighty Mule, and Ghost Controls systems. We’re an independent local company, not a DoorKing dealer, which means we don’t have to follow anybody’s script about what to sell you.
If your DoorKing access control is acting up in North Richland Hills, call (817) 241-4067. A live person answers, day or night, and the estimate is free. We’ll tell you over the phone if it sounds like something we can fix on this visit, and the price we quote is the price on the invoice.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving North Richland Hills and nearby areas.