Linear Gate Access Control Nationwide | Gatewood Fence & Gate

Linear Gate Access Control in North Richland Hills: What to Know First

Linear gate access control in North Richland Hills is something we install, repair, and upgrade as an independent Linear service provider. Most repairs run $185 to $430 and are finished the same visit, because we carry the boards, remotes, and keypads that fail most often on Linear systems. The price is quoted and agreed before any work starts. This page is for homeowners in North Richland Hills and the surrounding area who have a Linear opener or access system acting up, and who want a straight answer instead of a sales pitch. Call us at (817) 241-4067 and a live person picks up.

Call (817) 241-4067

How Linear Products Fail - and How We Fix Them

We’ve worked on Linear access control across North Richland Hills long enough to know which problems show up on which series. Here’s what we see most often, and what we do about it.

• APeX and ACT-34 keypads losing programming after a power bump. These keypads weren’t built for the voltage swings that come with our Texas thunderstorm season. The fix is usually a new memory chip and a surge suppressor on the low-voltage line, not a whole new keypad. We see this after nearly every good storm out near the Sam Lee Ballpark area.
• Megacode and Multicode remotes that open the neighbor’s gate, too. Older Linear receivers use fixed-code transmission that bleeds into adjacent DIP-switch channels. We replace the receiver with a rolling-code unit that keeps the opener but kills the interference. If your garage clicker has been opening the next driveway over, that’s the culprit.
• Linear gate operator boards that die from ant invasion. This is a North Richland Hills classic. The M-Series and L-Series boards sit inside a cabinet that ants love to nest in. We’ve pulled hundreds of boards where the failure wasn’t age or voltage, it was ant remains bridging contacts. We clean the cabinet, replace the board if needed, and seal the entry point so it doesn’t happen again.
• AP-5 and AP-3 photo eyes that trip on sunlight. The older Linear photo eye sensors are directional and can false-trigger when the afternoon sun hits them at the wrong angle. That’s why your gate starts closing and then reverses for no reason. Realigning and shading the eye usually fixes it; if not, we retrofit with a sun-tolerant sensor pair.
• Worn relays in Linear telephone entry systems at the gate panel. Linear’s AE-500 and AE-1000 telephone entry panels use mechanical relays that arc and wear out over a decade of use. The symptom is a gate that works from a keypad but won’t respond when someone calls from the panel. We replace the relay with a heavier-duty unit and get the panel talking again.

Our Linear Gate Access Control Process

1. 1
   You call, a live person answers. That’s not a slogan. We answer the phone at (817) 241-4067, day or night. We ask what the gate is doing, what brand you have, and when it started.
2. 2
   We come out and diagnose. We put a meter on the board, check voltage at the motor, test the keypad and remote receiver, and find the actual failure. No guessing.
3. 3
   We tell you the fix and the price before touching anything. You’ll know the number up front. If we find something else while we’re in there, we stop and call you. No surprise invoices.
4. 4
   We use OEM Linear parts where they matter, quality aftermarket where they don’t. Boards and receivers get OEM so the warranty stays clean. Keypads and photo eyes can often be aftermarket equivalents at half the price with the same reliability. We’ll tell you which is which and why.
5. 5
   We make the repair, test it, and clean up. We run the gate through at least ten full cycles, check the safety reverses, and make sure the remotes and keypads all talk to the new parts. The driveway looks like we were never there, minus the working gate.
6. 6
   The job carries the 90-Day Done Right Promise, in writing. If it’s not fixed right, one call brings us back. No runaround on that.

What Linear Gate Access Control Costs in North Richland Hills

Here’s the honest pricing picture for Linear gate access control work in North Richland Hills. These are the numbers we quote most days:

• Keypad replacement (Linear APeX or ACT-34): $185-$320 installed, depending on whether we reuse the existing wiring.
• Receiver upgrade to rolling-code (fixing cloned or cross-firing remotes): $240-$380, includes the new receiver and two remotes programmed on-site.
• Control board replacement (M-Series or L-Series): $290-$490, with a new surge protector on the low-voltage side.
• Telephone entry panel repair (AE-500 / AE-1000 relay replacement): $210-$360, including a full relay and wiring inspection.
• Photo eye sensor replace or re-align (AP-5 / AP-3): $160-$260 for a new pair installed and shaded.

What moves the price is whether we can reuse existing wiring and hardware, and whether the board survived or needs a new one. Every estimate is free, and the number we quote is the number you pay. Call (817) 241-4067 and we’ll give you a straight answer over the phone before we even schedule the visit.

Why North Richland Hills Homeowners Call Gatewood Fence & Gate for Linear Work

I’m Hal Gatewood. I’ve been fixing gates in North Richland Hills since 2001, and most folks around the Smithfield Road corridor know me or know someone who does. The name is on the shop, and the shop is down the road, that’s the oldest accountability there is. When you call, the person who answers is one of us, not a switchboard. We fix Linear systems because we’ve seen every failure these units are capable of, and we fix them right. If you’ve got another brand on the property, a LiftMaster, Mighty Mule, Ghost Controls, or DoorKing, we work on those too. The 90-Day Done Right Promise is stamped on every invoice in writing. If it’s not right, you call and we come back. And if I hand you my number, use it, that’s what it’s there for.

FAQs