Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Fort Worth
Gate access control in Fort Worth runs $280 to $1,450 for most keypad, remote, phone entry, and card reader jobs, and you’ll usually have a quote agreed before any work starts. The bigger deciding factor here isn’t the hardware. It’s the soil under the post. Fort Worth’s Blackland Prairie clay moves, heaves, and shifts with every wet-dry season, which is exactly why we treat post alignment as a standard part of access control work rather than an afterthought. If you’ve got a gate that grinds, reverses mid-cycle, or won’t respond to the remote after a hard rain, call (817) 241-4067 and talk to a person who knows Fort Worth’s dirt, not a call center three states away.
Why Gatewood Fence & Gate Is Fort Worth’s Preferred Gate Access Control Company
Hal Gatewood has been at this since 2001, and his name is on the shop and on every invoice our Fort Worth customers get. That sounds old-fashioned, and it is. It’s also the oldest accountability there is. When we tell you the problem is a heaved post, not a failed motor, we’ll show you where the post has shifted and why the operator’s out of alignment. You can drive to the shop and look us in the eye if you want to.
Our Fort Worth customers have a simple expectation: the person who shows up is the same person who will come back if anything isn’t right. The 90-Day Done Right Promise is stamped in writing on every job, not buried in fine print. One call brings us back. Calibration off? We fix it. Safety loop tripping after rain? We fix it. No runaround.
Every call to (817) 241-4067 is answered by a live person, around the clock. Not a voicemail. Not a robot. Hal or one of his background-checked crew members picks up, asks where in Fort Worth you are, and gives you a straight answer about when we can be there. That’s it.
Our Gate Access Control Services in Fort Worth
Keypad Entry
Keypad systems in Fort Worth fail for reasons that have little to do with the keypad itself. The post the keypad mounts to shifts in the clay, the wiring pulls loose at the junction, or years of 105-degree sun bake the membrane buttons until they crack. A standalone keypad entry install in Fort Worth typically runs $280 to $650, and we always bed the post or mount deep enough to ride out a wet winter. If your keypad works sometimes and not others, check whether the gate itself is leaning. That’s usually the tell.
Remote Control
We sync, clone, and program remotes for LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators. A new remote or receiver in Fort Worth generally runs $95 to $250. But here’s the thing we see over and over on the west side: the original operator is fine, and the gate itself is sagging or binding, so the remote “doesn’t work” because the motor is fighting the gate. We fix the gate first. The remote works after that. No swapping parts that don’t need swapping.
Phone Entry
Phone entry systems for gated Fort Worth communities let residents open the gate from their cell phone, and they’re becoming standard in the master-planned subdivisions along Chisholm Trail Parkway and the Alliance corridor. Installs typically run $450 to $1,200 depending on whether there’s cellular service at the gate and whether we’re integrating with an existing operator. Fort Worth’s flat sprawl actually works in your favor here: most gates have clear cell signal, and we don’t have to fight a limestone ridge to get a reliable connection.
Card Reader
Card reader and proximity systems in Fort Worth HOA gates need to handle Texas sun, ice, and the dust that blows in off the plains. A single-zone card reader install or replacement runs $350 to $900, and multi-resident systems with software for a management company run higher. The key is weather-sealed hardware and a reader that doesn’t fail when the temperature swings 60 degrees between Tuesday and Thursday. We stock what we need locally for Fort Worth customers so we’re not waiting on a shipment from California.
Video Intercom and Smart Access
Video intercom is the fastest-growing access control request we get from Fort Worth homeowners who want to see who’s at the driveway before they open it. A single-family video intercom with remote phone access typically runs $650 to $1,450, and it’s worth doing on a gate that’s actually plumb and square first. We won’t hang an expensive intercom on a leaning post. That’s backwards. Fix the post, set the operator, then the smart hardware does what it’s supposed to do.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Fort Worth
We’re certified to service nine major gate brands, and Fort Worth is full of them: BFT operators on estate gates in Ridglea, Linear and Ghost Controls units on ranch gates out toward the west side, and DoorKing systems at HOA entrances across the region. Because we weld on site and stock local parts, we’re not waiting for a distributor to ship a limit switch from Dallas. The most common brands we see in Fort Worth for access control specifically are BFT, Linear, and DoorKing, and we keep their common components on hand.
Common Gate Access Control Problems We See in Fort Worth Homes
- The gate reverses or stops halfway after rain. Fort Worth’s Blackland Prairie clay absorbs water and swells. A gate post that was plumb in August can heave over an inch after winter rains, which misaligns the safety loop, shifts the rack and pinion, and trips the operator’s safety-reverse on every cycle. The fix is re-setting the post, not turning off the safety loop. Anybody who disables your safety loop to stop the reversing is leaving you with a dangerous gate.
- Ice storms kill the limit switches and plastic gears. Freezing rain like Winter Storm Uri in February 2021 and the January 2023 ice event coats drive chains and limit switches with glaze ice, seizing motors and cracking plastic components. Fort Worth gates need operators with metal gears where it counts and weather-tight enclosures. We see this every single winter on automatic swing gates at HOA entrances.
- Aging wrought-iron gates retain original hardware that shears under automation. West-side estate gates in Fort Worth often keep their original hinges, latch keepers, and manual drop rods from decades before electric operators existed. When a motor starts applying force to hardware that was never designed for it, the hinge shears or the latch keeper fails. We weld reinforcing plates and replace worn hinges on site, then sync the remote so it opens cleanly without jerking.
- Keypad posts shift and the wiring pulls loose. This is the clay issue again, but it hits the access control mount directly. A keypad post that leans a few degrees puts strain on low-voltage wiring at the junction box, and eventually the keypad goes dead or works intermittently. We set access control posts in deeper, reinforced footings so you’re not calling us back because the ground rolled under the pad.
Pricing for Gate Access Control in Fort Worth, TX
Here’s what we tell Fort Worth homeowners before we ever schedule the truck. Keypad entry runs $280 to $650. A remote or receiver upgrade runs $95 to $250. Phone entry systems run $450 to $1,200. Card readers run $350 to $900. Video intercom and smart access run $650 to $1,450. Post-heave realignment work that’s necessary before any access control hardware goes on typically runs $200 to $500 depending on the size of the post, and you’ll know that number before we start because we quote it up front and agree on it together. Standing offers apply to every Fort Worth job: $40 off any repair over $200, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. We’ll also give you a free second opinion on any written estimate from another company, and we’ll do it without bad-mouthing them. Call (817) 241-4067 for a free estimate.
We Also Serve Cities Near Fort Worth
Beyond Fort Worth proper, our crews cover North Richland Hills, Hurst, Kennedale, and Bedford. If you’re in one of those communities and your gate access control is misbehaving, call us. As our Gate Access Control team tells everyone in the metro, the soil changes a little as you move off the Blackland Prairie, but the standard is the same: fix the gate right, stand behind it, and answer the phone. For more about our work across the area, see Gate Access Control in Fort Worth.
Serving Fort Worth, TX - Our Local Coverage Area
We’re based in the Fort Worth area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Fort Worth
Yes, in most Fort Worth master-planned communities including Walsh Ranch, you need architectural or HOA approval before changing the gate style, height, finish, or operator type. We help homeowners navigate that process by providing the spec sheet and installation details the management company asks for, and we coordinate directly with the HOA or property manager if you want us to. Call (817) 241-4067 and we’ll tell you what your specific community requires and how long approval typically takes.
In Fort Worth, the most common cause is post heave from Blackland Prairie clay, where a gate post set plumb in August can shift over an inch after winter rains and throw the loop detector out of alignment. The gate’s safety loop then trips, and the operator reverses mid-cycle. The fix is to re-set the post in a deeper, reinforced footing and recalibrate the loop, not to disable the safety feature. We see this as a routine seasonal call across central and west Fort Worth.
Yes, a properly configured video intercom with a cloud or cellular connection can give every resident app-based access, and we can provision different levels of access for guests, vendors, and management. For Fort Worth HOAs with shared entry systems, we coordinate with the management company on credentials and gate logs. The install has to be done on a gate that’s plumb and square first, or the intercom will read false obstructions every time the clay shifts. Call (817) 241-4067 for a site walkthrough and a written plan.
Absolutely. We retrofit automatic operators onto original ornamental iron gates all the time, but we always weld reinforcing plates at the hinge and latch points first, because original hardware from the pre-automation era wasn’t built to take motor force. We’ll re-hang the gate, reinforce the weak points, and install the operator and remote, then test it across the full cycle. The result is your original gate, now on remote control, without sheared hinges down the road. Most retrofits in Fort Worth run $1,200 to $2,800 including reinforcement and operator.
We size the solar panel and battery bank for Fort Worth’s actual winter conditions, which means assuming several consecutive days of heavy overcast and freezing rain. A small panel that works fine in July will leave the gate dead in February. We use sealed, cold-rated batteries, weather-tight enclosures, and operators with metal gears where it matters, and we angle the panel to shed ice rather than collect it. For an exact quote on a solar access control system, call (817) 241-4067. Estimates are free.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Fort Worth since 2001.
Call Gatewood Fence & Gate for Gate Access Control in Fort Worth
If your gate access control is giving you trouble in Fort Worth, call (817) 241-4067. You’ll get a live person, an honest answer, and a written quote before any work starts. Hal Gatewood’s name is on the shop, the shop is down the road, and every job carries the 90-Day Done Right Promise. We fix what’s actually wrong, and we don’t sell you parts you don’t need. Free estimates, senior and veteran discounts, and a second opinion on any written estimate you already have.